Waterjet Cutting Systems

Here's how abrasive waterjet cutting work ... high pressure, especially water, cutting tools, polishing is scary. Jet is a fine of up to 60,000 pounds per square inch of material can be cut thick or thin, hard or soft, including metal, paper, plastic, foam, glass, ceramics and composites. Part of the design as simple or complex involved, inside or outside the burr can cut spending by medium to high minimum kerf and no heat distortion or heat affected zone.

Distilled water free of ions and pure pressure in the pump, intensifier, to head off and forced through a small hole in a Stream linked, which impinges on the specimen, because the water represents the cutting edge much more potent than pure water, abrasive can be introduced in the mixing room under the entrance and exit through the nozzle stream. Thus, the term "Water Jet" and "Water jet abrasive" Jetting to the U.S. market, "direct injection" system: the water and ready-wear and a mixture is injected directly into the head.

Water jet cutting machine

Control of movement, either manually or automatically. Manual systems can be used for the shape of shares, respectively, the part about the jet's head that would trap the water below. It can also be used for trimming or recommend fixtured, unfixtured parts that occur with similar routing with fixed or mobile phone. Automated system exists in a full range from CNC machine gantry for cutting images in the program stack of plates and sheets, as well as inventory stacked to multiaxis system, 3-D cut to yield head off many. can be used to cut sheet and plate. Automated system can also include a table shuttle unloading equipment, water flow self-cleaning tanks, and other auxiliaries Motion control components are protected from water and to scrub