- testing should reduce some of the different part of the speed that you expect to cut Therefore, participation and look for angles in a corner outside the radius, etc., then the small will be featured all of these programs to it and cut it so that you get the idea that these methods will look like in the. completed.
- Write down home location.
 |
| Waterjet Cutting Glass |
- decide whether to stop the program if you need to be cut in the middle of the other terms are the parts not important to tolerance. In the case of gears, a lot of internal and tips of each tooth is not exposed to anything and that is why it is in the air. This result is a good place to stop the program and do any tests.
- When you have one on the table, run programs with only water at high speed. This will mark the material and verify that the part will fit on a piece of material and correct your settings.
- If you have a program to stop or you will be a failure of power do not trust the location in which you write down However, start and run only the first part of water and make sure you cut the following have done already. You also might want to move to another part of the program and make sure that the line is still up there. I always worry that when you start the program you may be several thousand to a few inches away from this position and may not be good.
- When you cut through part of the blade to cut out all the teeth grinding, so you have some measure of length that will fit into the kerf has been removed. Assume that this data is 6 "thick mark on the blade that 6.5" Then take the knife and put into cutting and the bottom of the blade sticking out the bottom, slide the blade along. the engine and check that the material is cut all the way through. Of course, you will need to make allowance for grates, but this will give good advice on the state of the bottom of the cut.
- Make sure you wear is fine and set up.
- Use the coarsest difficult, garnet stone, you can have a combination of your mouth nozzle. If you try to use the net hard rock 50 to 40 nozzles.
- Check the accuracy
- Ideal diamond put in your mouth as this is the way to a more reliable, especially when the material you will cut the high cost.
- Check the condition of the injectors.
- Check that the head is cut vertically, as if not tolerance of the parts are not secure. To do this line by the head or drilling small holes in some of the cutting head lifted up and flows should go to the hole. If that is not vertical, it will walk 'out of the hole and the direction of cut will tell you how to cut your head to be adjusted.
1 comment:
I read your post and got it quite informative. I am impressed by the details that you have shared in this post and It reveals how nicely you understand this subject. Colored Optical Glass Filters By Valley Design.
Post a Comment