Cutting thick materials. Tips & Guidelines.

Tips and Guidelines - Cutting thick materials
• testing should reduce some of the different part of the speed that you expect to cut Therefore, participation and look for angles in a corner outside the radius, etc., then the small will be featured all of these programs to it and cut it so that you get the idea that these methods will look like in the. completed.

• Write down home possition.

• Some operations interrupted while you may need to do is to cut the long

Waterjet Cutting Process

• decide whether to stop the program if you need to be cut in the middle of the other terms are the parts not important to tolerance. In the case of gears, a lot of internal and tips of each tooth is not exposed to anything and that is why it is in the air. This result is a good place to stop the program and do any tests.



• When you have one on the table, run programs with only water at high speed. This will mark the material and verify that the part will fit on a piece of material and correct your settings.

• If you have a program to stop or you will be a failure of power do not trust the location in which you write down However, start and run only the first part of water and make sure you cut the following have done already. You also might want to move to another part of the program and make sure that the line is still up there. I always worry that when you start the program you may be several thousand to a few inches away from this position and may not be good.